![]() ![]() Have also installed the ST-LINK utility V4.1 in an attempt to connect to the ST-LINK/V2 device but it reports that it is unable to connect (as to be expected since the USB devcie driver is not working). Extract the archive and run either dpinstamd64.exe or dpinstx86. Just wanted to verify that the ST-LINK/V2 will work with a USB3 port?Īlso I have a Silicon Labs device driver installed for a USB connection that I make to a Digilent Zybo board using Vivado and wondered if this could be conflicting with the functionality of the ST device driver? As far as I remember in the past this should show as an ST labelled device (cannot remember the exact naming). In device manager, under Universal Serial Bus Controllers, I see a device that is marked as Unknown USB Device (Device Descriptor Request Failed). ![]() The last device you connected to this computer malfunctioned. Once connected, wait for the driver to install. CC256x STM32 Bluetopia SDK v4.0.2.2 In the APIs demo example says that 'Once the code is flashed, connect the board to a PC using a miniUSB or microUSB cable. In the meantime, to test the interface, I attached an ST-LINK/V2 device to a USB port and Windows displays the following message. CC2564MODN: STM32 STLink COM port driver problem on Windows 10. I am intending to work with the NUCLEO-L476RG board which I will have shortly. ![]() The ST-LINK boards feature an STM32 32-bit microcontroller based on the Arm ® Cortex ®-M processor. However, ST-LINK driver installation is required for previous ST-LINK generations. I have installed SW4STM32 V2.2 onto a Windows 10 64bit PC including the drivers required for the ST-LINK debugging and programming interface. Note: STLINK-V3 boards can be recognized by Windows ® 10 without any driver installation. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |